In all heavy iron Models,I was able to control the speed break lever with my mouse...Was able to increase or decrease by dragging..now I can only extend to a partial ,and then it goes full..this with no retracting..I had this ,and now don't..That is full up and down control. The key board "/"..still works ..only full up,or full down..no incremental control...Any Ideas or adjustments?...tried using different Mouse...no Go!..thanx..Vin
Hi Roger,On most Heavy Iron Models,..The Spoilers are deployed in increments.On the cockpit Controls,You as you know,Deploy landing Grear,Flaps and Spoilers...With your mouse pointer.,as a draggier!..Done it ,with no problems...But As with this Sim,"STUFF" happen's... ;D.!!
..In One of these Pics you will see the setting at 40%..I will play with it..Must be a mouse adjustment...Thanx ..vin!!
Thanks Dave as always!!...yes the Key board "/" or "shift /" will work. Using the Default 737...try to show the remote quadrant with ,Shift 5...now with no start up,drag the mouse on the Spoiler lever...it will show degrees of settings...as well displaying that in in the Cockpit Quadrant......Both will move.However the Cockpit quadrant will not in any attitude, move.....I found that on the cockpit lever,with the mouse arrow on it..there seems to be an elusive "Sweet Spot"..If you can get on it it works......So it may be in the soft touch,and not with meat handed efforts.you can get results...I Dunno. ;D..Meanwhile finding this in a busy Solo, work load, on finial...will and does result in a crash....Spoilers when required ,are an integral part of smooth landings.......Its the "WHO NELLIE" pulling the reigns back of planes!...Some things never change!! .Having Fun..Vin
Hi Dave.."THE REST OF THE STORY"...It works well in the default Air Bus...No Problem..it works as I describe it should....HOWEVER....I installed the beautiful FSX Default Boeing 737-800 Upgraded Cockpit by by: Alejandro Rojas Lucena. Not at all criticizing,the great Alejandro, this my be the issue at hand however!...I will Live with It..again Thanks much!..Vin!!