|
Post by finnflyer on Mar 25, 2013 11:00:09 GMT -5
GAS PitcairnX for FSX Pack questions. Hi! I have bought some days ago GAS PitcairnX for FSX Pack. I'm a newbie I'd like to know, how use autogiro. Here's a little bit about PC software. I have Windows 7 Premium 64 bit and FSX De Luxe Edition in which I've installed SP1 + SP 2. 1. Why gauges and effects must add separately in PCA-2 PA-18 main folders. Usually they are "built in" crafts folder. 2. I opened cockpit view, both crafts, gauge pop ups are missing!! only blanks are visible. I checked out panel folders, there are .cab zip in. quite odd.. I've got new gauges .cab from GAS now gauges are shown. 3. When starting to flight, both crafts, props. and rotors are running, is it OK. PA-18 has pink rotor silhouette and PCA-2 has grey one when running, is this OK. PA-18 works fine, no problem, but PCA-2 has problems. 1. When starting to flight. I pushed full throttle and pull Yoke max position as I do with PA-18. take off is OK, like PA-18 has, but then PCA-2 is dropping on the surface and take off again, it acts so continuously, short leaps leaps leaps and so on. What's the matter. 2. About PCA-2 Rotor clutch and Rotor brake levers doesn't work properly Rotor brake lever is pushed in, not pulled out, as shown in picture. Rotor clutch lever is shown 7"o'clock, but after turning it 10" o'clock, it isn't hold. Is Pitcairn PCA-2.air, or aircraft.cfg. damaged and cause this. Regards: finnflyer
|
|
|
Post by spad54 on Mar 30, 2013 5:48:02 GMT -5
Hi Finn Flyer I sent you an e-mail with more detailed explanations.
|
|