Orcas Island mesh included with Classic Travel Air

[philipp]

Hi,

it is amazing that a mesh scenery, which fixes terrain-problems for Orcas Island scenery, is included in your Classic Travel Air package. I am useing FS Global 2005 and I had bad and very ugly incompatibilitations useing it together with Orcas Island scenery. And your wonderful mesh scenery fixed all problems. But if I change

"terrain_max_vertex_level=x"

in the scenery.cfg with a number higher than 19 I get nearly the same problems as if I would use FS Global 2005 with Orcas. But if I switch back to 19 everything is very well.
I must keep "terrain_max_vertex_level=21" because I use very much terrain mesh scenerys on the whole world and these scenerys requiere the layer number 21 to work as good as they are.
It would be so wonderful, amazing, incredible ... ;D if you could make the wonderful Orcas mesh fix from your Classic travel Air package work with a layer which is higher than 19.
Is that possible for you ? I hope, hope and hope.

Thank you very much in advance.

Regards

Philipp

[Admin]

Orcas Island was made by Richard Goldstein on the default mesh and at terrain_max_vertex_level=19 It is not compatable with any commercially available mesh. Bill made a small patch to enable the use of 38m mesh all around Orcas. However there is no way Richard's scenery can be used if terrain_max_vertex_level is above 19. TMVL=21 totally ruins Richard's work and there is no fix. This is true of all GeoRender scenery BTW, not just Orcas.

[philipp]

Hi Tom,

thanks for your answer.

Philipp