|
|
Post by Admin on Sept 6, 2007 10:35:01 GMT -5
Is there a quick and easy way to remove a single bridge in FSX?
Specifically the one at N44 16.78 W68 41.01 The default bridge is in zig zag sections for half a mile across a causeway. The actual bridge is about 30 ft. long in the middle of the causeway and the underlying road is a more accurate representation. I'd like to remove the bridge sections.
|
|
|
|
Post by Dave3cu on Sept 6, 2007 13:42:47 GMT -5
I was able to exclude using the 'exclude rectangle' function within AFX. They excluded as 'library objects'. I don't have the SDK so at present I rely on AFX and Instant Scenery to do my work.  Dave |
|
|
|
Post by Admin on Sept 6, 2007 15:52:06 GMT -5
I was able to exclude using the 'exclude rectangle' function within AFX. They excluded as 'library objects'. I don't have the SDK so at present I rely on AFX and Instant Scenery to do my work. Dave Thanks Dave. It took some of the road as well. I use AFX myself so I'll mess with it when I get back from vacation. edit: Actually, I'm also using UTX so maybe the road will remain. |
|
|
|
Post by Dave3cu on Sept 6, 2007 16:33:45 GMT -5
I'm my view, before excluding the bridge, there was very little road under the bridge. From each end it only went to the first piers, or so.
It would require the road be extended from each end to meet a shorter bridge.
Dave
|
|
|
|
Post by Admin on Sept 6, 2007 17:47:40 GMT -5
With Ultimate Terrain X, the road goes all the away across under the bridge. so that will work for me. I'll try texturing the causeway and perhaps put in the short bridge. I may give it a shot before bedtime.
|
|
