|
Post by Dan on Jan 9, 2009 5:56:01 GMT -5
I think I just found the 'Round the World' flight plan that I've been looking for, for sometime now - except there is no 'flight plan'. Found it the other night searching for one that had the places I wanted to see with the general direction I wanted to fly in and with the same general DC-3 like planes that I wanted to fly it with. It was originally written in 'trip' form as a story by Nigel Mason (May 24, 2005). It details all the places, stops (43), and how he flew it, but as noted, no flight plan file. Therefore, can anyone point me to a good tutorial that presents the best and easiest method(s) of creating a 'long' flight plan in somewhat of an accurate manner loadable in one file format? I will be using a GPS for most of the flight, but might experiment with earlier forms of navigation for those times - 30's-40's and of course flying DC-2/3/4/6s, Convairs, Connies, etc. The article that he wrote is called "Around The World In About Two Hundred and Eighty Days" - available at FlightSim.Com. www.flightsim.com/cgi/kds?$=main/feature/round.htmBruce, I know your busy with the "Solo to Sydney", Francis Chichester flight, so any suggestions of a good tutorial would be fine and anyone else with any good pointers would be most appreciated, before I attempt this. Thanks Dan …it’s great being a kid again – without the glue! ;D
|
|
|
Post by reddog on Jan 9, 2009 16:38:42 GMT -5
Assuming that you are Flying in FS9 couldn't you set that up using FSNavigator?
|
|
|
Post by bhk on Jan 9, 2009 18:11:56 GMT -5
Dan, Possibly the "easiest" (certainly the quickest to access) is the inbuilt tutorial in FS9. You'll find it under the Learning Centre - it's called "Flight Planner" and is found under the KeyTopics tab.
By far the best (IMO) planner for FS9 is FSNavigator as it is so flexible. I do all my planning in FSNav as it allows one to place waypoints anywhere, whereas FSim's default Flight Planner only allows airports and nav-aids to be used as route waypoints. That's fine for the period since WW2 but not realistic for periods prior to that. The only drawback is that you cannot then save such a plan into FSim if anything other than default waypoint nodes have been used, so it's not possible to share that plan with anyone not using FSNav.
FSNavigator was pay-ware but I think it is no longer available - not sure.
I'd opt for having a look at the default tutorial, Dan, and see how you go with that.
Regards, Bruce
|
|
|
Post by Dan on Jan 10, 2009 4:49:21 GMT -5
Assuming that you are Flying in FS9 couldn't you set that up using FSNavigator? I wish I could, Reddog, but seems it's no longer available, unless your a registered user for the last version of it. www.fsnavigator.com/Dan, Possibly the "easiest" (certainly the quickest to access) is the inbuilt tutorial in FS9. I'd opt for having a look at the default tutorial, Dan, and see how you go with that. Regards, Bruce I believe that's what I'm going to do, Bruce. Though I just downloaded a program from this site - www.myoddweb.com/ called 'Courseplanner'. Not sure how good it is or if it's what I want, but I do like the 'printable' map feature wiki.myoddweb.com/Main_Page. There's no documentation for this version yet, so downloaded an earlier version from Simviation.com - simviation.com/fs2004utilities6.htm. Either way, it should be a good learning experience. I've done small flight plans with the FS9 Default Planner before, but nothing on this scale. Thanks for the advice! Dan …it’s great being a kid again – without the glue! ;D
|
|